Introduction
Hood deflectors or commonly called bug deflectors are popular among car owners since time memorial. They guard the windshield against insects, rocks as well as other particles on the road. One issue is the hood deflector interfering with the hood or some other part of auto. This might prove destructive to the part in question, the deflector, as well as the car in general. That's where small clear cone-shaped bump stops come in handy.
What are Small Clear Cone-Shaped Bump Stops?
Small clear flared cone shaped bumper rubbers are small clear rubber or plastic units that are fitted between the hood deflector and the hood. They serve as a cushion and ensure that two abutting parts do not come into contact with each other and thus causing wear. These bump stops are made small and clear and this is in order not to hinder the look of the hood deflector.
Uses of Small Clear Cone-Shaped Bump Stops
Prevent Damage to Hood Deflector: Bump stops installed under the front part of the hood also minimize the force with which the hood deflector hits the hood which then helps to reduce the chance of a damage to the deflector. As can be seen this could help you avoid incurring large expenses on repairs or even replacements.
Protect the Hood: Bump stops also assist in shielding the hood of your car from scraths and dents that may occasionally be inflicted upon it by the hood deflector.
Improve the Appearance of Your Vehicle: Aesthetics are of less concern in this case because these bump stops are designed more or less to be subtle, really inconspicuous in fact, and that for this reason you should not worry about them being eye-sores in your car.
Advantages of Using Small Clear Cone-Shaped Bump Stops
Easy to Install: Both these bump stops are extremely easy to install. They can generally be installed with double sided tape or adhesive.
Durable: Bump stops are made from materials that are quite strong so will remain intact if exposed to the weather.
Affordable: These accessories are quite affordable, therefore you do not have to spend too much money to get your vehicles shielded.
Customizable: Depending on the dimensions, you can select from a wide range of size and shape to have right bump stops for the hood deflector.
Installation of these small clear cone shaped Bumper Stops
Clean the Area: Those who wish to fit their first generation Fortuner with the new Toyota bump stops should first ensure that the surface where the dampers are going to hook onto is clean. This will be to make sure that once applied it will be easy for the adhesive to attach it self to the surface you intend to attach.
Apply Adhesive: Spread the glue on the back of the bump stop as well.
Attach the Bump Stop: Push the bump stop neatly into the position marked by the hood deflector and the hood.
Allow to Dry: Don’t drive your car immediately after applying the adhesive, let it dry first.
Proper Care and Maintenance
Check for Wear and Tear: Se also scan the rubberised cushion like surfaces or the bump stops for any signs of rapping or deformation. In the case that they are found to be faulty, they should be replaced without delay.
Clean the Bump Stops: There are few care tips which helps a lot in maintaining your and they are mentioned below: you should clean your bump stops with mild detergent and water only.
FAQs
Can I use these bump stops with any hood deflector?
Yes, these bump stops can be used with most hood deflectors.
How long do these bump stops last?
With proper care and maintenance, these bump stops can last for several years.
Are these bump stops difficult to install?
No, these bump stops are very easy to install.
Conclusion
One of the simplest yet quite efficient measures that will prevent hood deflector and the hood of your car from dings are small clear cone-shaped bump stops. These accessories can be easily installed and cost little money, but they are also long-wearing. With these bump stops, you are in a good position of making sure that your vehicle retains that stunning looks for as long as possible.
0 Comments